This delightful gift card and treat box holder was cased from Intatwyne Designs using products from the Wrapped in Plaid suite. Yes there are a lot of pieces but once cut and put together it makes a delightful gift box, he box itself holds 3 Ferrero Rocher® but you can anything else you like.
- Coloured Cardstock
- base – 11-1/4 x 7-3/4 inches. on short side score at 1/2, 1-7/8, 5-7/8, 7-1/4 inches, make a mark at 1-1/4 inches; on long side score at 1/2, 1-7/8, 3-1/4, 4-5/8, 8-3/8, 10-3/4 inches, make a mark at 6 inches
- sentiment – 2 x 1 inches
- piece for stamped tree
- Gold foil
- front of card section – 3-3/4 x 2-1/8 inches
- top and front box pieces – 2 pieces 3-3/4 x 1-1/8 inches
- box ends – 2 pieces 1-1/8 x 1-1/8 inches
- sentiment – 1-1/8 x 2-1/8 inches
- DSP
- front of card section. – 3-5/8 x 2 inches
- top and front box pieces – 2 pieces 3-5/8 x 1 inches
- box ends – 2 pieces 1 x 1 inch
- back of box –
- Whisper White cardstock for message on back if required
The sentiment and tree is heat embossed in white. The base once scored and burnished needs to be cut as shown below.
The gold foil and DSP pieces are added as shown to the front.
Fold the the tabs and adhere as shown
Punch a finder hold in the open side to be able to remove the card, add DSP and Whisper White to the reverse for message if required.
Add the sentiments and tree to the front panel and apart from adding contents this is now complete.
Thank you for looking and hope you enjoyed this project. The supplies are listed below and linked to the online store, I would love to be your demonstrator if you are interested please contact me.
Linda x
Product List
